bdg_customs001028.jpg
Owned and operated by BDG Customs. Copyright © 2012. All Rights Reserved.
This shield was designed to work with the Arduino Mega and Mega ADK
Arduino Mega ADK Prototype Shield
bdg_customs013015.jpg bdg_customs013014.jpg bdg_customs013013.jpg bdg_customs013012.jpg
Some of the features of this Board:
bdg_customs013011.jpg
See it @
bdg_customs013010.jpg
All pin silk is around the outside edge of the board
(Allows the silk to be seen even after the board is populated or if a breadboard is used in the center)
 
Board layout eliminates the problem of shorting to the USB housing
(Many proto shields go over the USB housing and can short your circuit to GND)
 
All input and output pins have a extra hole routed
(Allows access to a hole to solder to even if connectors are installed)
 
5V and GND are pulled out to a strip in the center
(Allows access to a hole to solder to even if connectors are installed)
 
All mounting holes are present and match the Mega Layout
(Allows for easy mounting and securing of the shield)
bdg_customs013009.jpg bdg_customs013008.jpg bdg_customs013007.jpg bdg_customs013006.jpg bdg_customs013005.jpg bdg_customs013004.jpg bdg_customs013003.jpg bdg_customs013002.jpg bdg_customs013001.jpg